Blind spot rearview mirror - convex - plastic MNC 55678

Rearview mirror with a wide viewing angle and blind spot reduction. It can be installed on any mirror with a frame, whether it is an external or an internal mirror. The dome mirrors installed on the left and right side reduce the dead space next to the car, making driving safer. It can be an ideal choice for training cars and beginner drivers. If installed on the center mirror, you can, for example, observe children, babies, and pets sitting in the back seat.

• Convex mirror
• It can be adjusted vertically and horizontally
• Safe transportation
• Easier lane change
• You can observe the people sitting in the back
• Universal, can be mounted on most mirrors
• Accessories: star wrench tool

Installation on exterior mirror:
1. Unscrew the screw on the back of the mirror housing and remove the mirror plate!
2. Place the clamping bracket in the opening at the bottom of the mirror housing. The holes for the screws should be inside the mirror housing and the top of the „U” profile should face forward.
3. Tighten the screws until the mirror housing is properly attached to the factory mirror. Do not overtighten the screws, as this may lead to breakage of the mirror housing, but be aware that a mirror falling off while driving is dangerous.
4. After installation, make sure that the mirror housing is properly and securely attached.
5. Reassemble the mirror plate using the screw on the mirror housing, then adjust it to the desired angle.

Installation on interior mirror:
1. Unscrew the screw on the back of the mirror housing and remove the mirror plate!
2. Place the clamping bracket in the opening at the bottom of the mirror housing. The holes for the screws should be parallel and flush with the mirror plate.
3. Tighten the screws until the mirror housing is properly attached to the factory mirror. Do not overtighten the screws, as this may lead to breakage of the mirror housing, but be aware that a mirror falling off while driving is dangerous.
4. After installation, make sure that the mirror housing is properly and securely attached.
5. Reassemble the mirror plate using the screw on the mirror housing, then adjust it to the desired angle.